![]() 2) How to set the model no? as above? 3) The Waveform Generator function is not working now. Please set instrument serial and licensing model numbers. My query is below: 1) On power-on it shows - WARNING - Unfinalized Software.Is this normal? or okay? 2) Also displayed just after it turns fully ON is: System Concerns detected: - Instrument is Uncalibrated Secure Storage is uninitialised. After 'successfully' installing the firmware as per the instructions, in the 'About this Oscilloscope' tab it shows the below info: Model number: Unset Serial no 7290 Bandwidth: 200MHz Module Installed: None Firmware version: 022736 Installed Licences: MSO, SGM,BW20,EDK,WAVEGEN,DVM,RML Now the scope comes on normally except that instead of Agilent the Keysight logo is displayed. and had installed licences of MSO, BW20, WAVEGEN. My previous firmware was version 1031600. ![]() So after reading posts on this forum, which matched my above problem, I updated the firmware. The Agilent screen was up and stood still. ![]() Control Modules: : Update of Firmware Bulletin FWController: Control Modules: : Added firmware D.01.04001 for the InfinityLab Companion for all Infinity II FUSION based modules (to be used with LC FW D.07. It just continued the sequence of lighting the LED's in a sequence during start up and continued forever. Added firmware release B.02.24 for the G4208A Instant Pilot. Need help on the following issue: It started with the MSO-X 3024A Agilent infiniivision getting into a never ending loop during power-ON.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |